# FabCore camera mount

**URL:** <https://community.fabcreator.com/t/fabcore-camera-mount/153>\
**Category:** General Discussion\
**Created:** [30 September 2021 19:35 UTC](https://community.fabcreator.com/t/fabcore-camera-mount/153 "2021-09-30T19:35:14Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![stressi](https://community.fabcreator.com/letter_avatar_proxy/v4/letter/s/c2a13f/32.png) [@stressi](https://community.fabcreator.com/u/stressi)\
**Post date:** [30 September 2021 19:35 UTC](https://community.fabcreator.com/t/fabcore-camera-mount/153/1 "2021-09-30T19:35:14Z")

</div>

hello together,

i installed a 5MP camera in FabCore. Therefore i designed a flatter mount than the official one provided by Lightburn. If anybody have the intention to install a camera to FabCore i guess this  
is a good solution for everybody.

If there are any questions or constructive improvements please let me know.

[https://www.prusaprinters.org/prints/77508-camera-holder-for-5mp-usb-camera-model](https://www.prusaprinters.org/prints/77508-camera-holder-for-5mp-usb-camera-model)

---

<div class="post-metadata">

**Author:** ![ploenne](https://community.fabcreator.com/letter_avatar_proxy/v4/letter/p/f0a364/32.png) [@ploenne](https://community.fabcreator.com/u/ploenne)\
**Post date:** [1 October 2021 07:30 UTC](https://community.fabcreator.com/t/fabcore-camera-mount/153/2 "2021-10-01T07:30:57Z")

</div>

Hi stressi

thanx for the tip.

---

<div class="post-metadata">

**Author:** ![FabCreator](https://community.fabcreator.com/user_avatar/community.fabcreator.com/fabcreator/32/7_2.png) [@FabCreator](https://community.fabcreator.com/u/FabCreator)\
**Post date:** [5 October 2021 11:00 UTC](https://community.fabcreator.com/t/fabcore-camera-mount/153/3 "2021-10-05T11:00:30Z")

</div>

Thanks for sharing @stressi curious to where you mounted it in the FabCore?  
Did you manage to make use of the expansion port we left at the side for a camera usb port?

---

<div class="post-metadata">

**Author:** ![stressi](https://community.fabcreator.com/letter_avatar_proxy/v4/letter/s/c2a13f/32.png) [@stressi](https://community.fabcreator.com/u/stressi)\
**Post date:** [5 October 2021 13:54 UTC](https://community.fabcreator.com/t/fabcore-camera-mount/153/4 "2021-10-05T13:54:08Z")

</div>

Hello Bonne,

yes i used the extension slot in the device. Cable mounting within device i handled with self glued cable mounts. The holder for camera is also glued with double-sided tape on the inner side of the door.