Looks way better with 3mm off each side profile. The bed is levelled and moves fine.
I just need to figure out something about the Z and Y endstops:
After hitting one, I can't go on the other direction. X axis isn't affected but is the only one homing to min.
moving down > hit z_min > machine goes halt > clear alarm > move up > motors are powered for half a second then it goes to halt again saying a limit is reach.
same happens when going up.
M119 gives me correct values
It's a bit annoying because if the bed hit the bottom switch I have no mean to make it move other than move the machine and crank the belt manually.
Maybe home_to_min and flip min and max wire can do it.
Anyone has this one too ?